Figure 18 Rs4000 And Antenna Installed In Nema Enclosure - Meru Networks AP150 Installation Manual

Installing the RS4000
Mounting the RS4000 in the Hoffman/NEMA Enclosure
Caution!
Laboratories.
To mount the RS4000 in the Hoffman/NEMA enclosure, it is necessary to use the
optional mounting plate that is not supplied with the RS4000 packing items. This
procedure assumes the Hoffman/NEMA enclosure is already mounted at the site.
1. Remove the wall bracket from back of the RS4000, if attached, by unscrewing
2. Attach the Hoffman/NEMA mounting plate to the back of the RS4000.
3. Attach the right-angle elbow joint to the antenna cable, if not already attached.
4. Attach the two antenna cables to the SMA antenna connectors labeled
5. Attach two Ethernet cables to the Ethernet ports labeled
6. Place the RS4000 into the Hoffman/NEMA enclosure, and align the plate
7. Pass the Ethernet and antenna cables out of the Hoffman/NEMA enclosure through
8. Tighten the captive screws on the mounting plate to the Hoffman/NEMA
9. Attach the antenna cables to the antenna (see
10. Position and align the bottom of the antenna over the threaded stud on the
NEMA box
Figure 18: RS4000 and Antenna Installed in NEMA Enclosure
26 Meru Access Point and Radio Switch Installation Guide
This method of mounting has not been evaluated by Underwriters
each of the 4 knurled thumbscrews.
on the top panel of the RS4000 (see
ANT2
clockwise until tight.
top panel of the RS4000.
screwholes with the holes in the Hoffman/NEMA enclosure.
the cable pass-through holes.
enclosure.
antenna mount arm and tighten the threaded stud to the antenna.
Antenna
Figure 8) by turning the cable ends
Figure
RS4000
ANT1
and on the
ETH1 ETH2
15).
© 2007 Meru Networks, Inc.
and