Figure 37 Mounting The Ap150 To A Suspended Ceiling Rail - Meru Networks AP150 Installation Manual

Installing the Access Points
Mounting Below a Suspended Ceiling
The optional suspended ceiling mounting kit allows the AP150 mounting bracket to
attach to suspended ceiling T-rails (see
Note:
to attach the AP150 to the mounting bracket.
Figure 37: Mounting the AP150 to a Suspended Ceiling Rail
To mount an AP150 below a suspended ceiling:
1. Using a 1/8" Allen wrench, remove the shoulder screws from the mounting
2. Determine the location on the ceiling rail where the AP will be mounted and
3. Place each of the two caddy fasteners on the ceiling T-rail and twist to attach to
4. Adjust the distance between the caddy fasteners by using the mounting bracket
5. Tighten the caddy fasteners in place using a standard screwdriver. Do not
6. Place each spacer on the caddy fastener stud. The spacer legs should contact the
7. Align the mounting bracket keyholes with the caddy fastener studs and slide the
56 Meru Access Point and Radio Switch Installation Guide
To comply with NEC code, attach a grounding wire to any of the screws used
Washers
bracket, if already attached.
remove the ceiling tiles.
the rail.
holes as a guide.
overtighten.
ceiling T-rail.
AP150 to the narrow end of the hole.
Figure 37).
Suspended ceiling T-rail
Caddy fastener(s)
Spacer(s)
Mounting bracket
© 2007 Meru Networks, Inc.