Endress+Hauser Levelflex FMP51 Operating Instructions Manual page 241

Levelflex FMP51, FMP52, FMP54 FOUNDATION Fieldbus
Assign measurement variable
Navigation
Description
Selection
Factory setting
Additional information
Process variable value
Navigation
Prerequisite
Description
User entry
Factory setting
Additional information
Switch output simulation
Navigation
Description
* Visibility depends on order options or device settings
Endress+Hauser
Description of parameters
Navigation  Expert → Diagnostics → Simulation
 Expert → Diagnostics → Simulation → Assign meas.var.
Selct process variable to be simulated.
• Off
• Level
*
• Interface
• Level linearized
• Interface linearized
• Thickness linearized
Off
• The value of the variable to be simulated is defined in the Process variable value
parameter (→  241).
• If Assign measurement variable ≠ Off, a simulation is active. This is indicated by a
diagnotic message of the Function check (C) category.
 Expert → Diagnostics → Simulation → Proc. var. value
Assign measurement variable (→  241) ≠ Off
Specify value of the process value being simulated.
Signed floating-point number
0
Downstream measured value processing and the signal output use this simulation value. In
this way, users can verify whether the measuring device has been configured correctly.
 Expert → Diagnostics → Simulation → Switch sim.
Switch the simulation of the switch output on or off.
Operating menu



241