Endress+Hauser Levelflex FMP51 Operating Instructions Manual page 187

Levelflex FMP51, FMP52, FMP54 FOUNDATION Fieldbus
Manual thickness upper layer
Navigation
Description
DC value
Navigation
Description
Use calculated DC value
Navigation
Description
Endress+Hauser
"Automatic DC calculation" wizard
The Automatic DC calculation wizard is only available when operating via the local
display. When operating via an operating tool, all parameters concerning the
automatic DC calculation are located directly in the Interface submenu (→  182)
In the Automatic DC calculation wizard two parameters are displayed simultaneously
on the display module at any one time. The upper parameter can be edited, whereas
the lower parameter is displayed for reference purposes only.
Navigation 
 Setup → Advanced setup → Interface → Autom. DC calc. → Man.thick.up.lay
→  184
 Setup → Advanced setup → Interface → Autom. DC calc. → DC value
→  185
 Setup → Advanced setup → Interface → Autom. DC calc. → Use calc. DC
→  186
Setup → Advanced setup → Interface → Autom. DC calc.
Operating menu



187