Endress+Hauser Levelflex FMP51 Operating Instructions Manual page 216

Operating menu
Factory setting
Additional information
Decimal places menu
Navigation
Description
Selection
Factory setting
Additional information
Backlight
Navigation
Prerequisite
Description
Selection
Factory setting
Additional information
216
Decimal
The ft-in-1/16'' option is only valid for distance units.
 Setup → Advanced setup → Display → Dec. places menu
Select number of decimal places for the representation of numbers within the operating
menu.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xxxx
• Is only valid for numbers in the operating menu (e.g. Empty calibration, Full
calibration), but not for the measured value display. The number of decimal places for
the measured value display is defined in the Decimal places 1 to 4 →  213
parameters.
• The setting does not affect the accuracy of the measurement or the calculations.
 Setup → Advanced setup → Display → Backlight
The device has the SD03 local display (with optical keys).
Switch the local display backlight on and off.
• Disable
• Enable
Disable
Meaning of the options
• Disable
Switches the backlight off.
• Enable
Switches the backlight on.
Regardless of the setting in this parameter the backlight may be automatically
switched off by the device if the supply voltage is too low.
Levelflex FMP51, FMP52, FMP54 FOUNDATION Fieldbus

Endress+Hauser