Task
Display summary information
about all aggregation groups.
Display detailed information about
a specific or all aggregation
groups.
Clear LACP statistics for a specific
or all link aggregation member
ports.
Clear statistics for a specific or all
aggregate interfaces.
Ethernet link aggregation configuration examples
In an aggregation group, only ports that have the same port attributes and class-two configurations (see
"Configuration
Make sure that all member ports have the same port attributes and class-two configurations as the
reference port. The other settings only need to be configured on the aggregate interface, not on the
member ports.
Layer 2 static aggregation configuration example
Network requirements
As shown in
Device A and Device B are connected through their respective Layer 2 Ethernet interfaces
•
GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3.
Configure a Layer 2 static aggregation group on both Device A and Device B. Enable VLAN 10 at
•
one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20 at one
end to communicate with VLAN 20 at the other end.
Enable traffic to be load-shared across aggregation group member ports based on the source and
•
destination MAC addresses.
Figure 9 Network diagram
classes") as the reference port (see
Figure
9:
Command
display link-aggregation summary [ | { begin |
exclude | include } regular-expression ]
display link-aggregation verbose
[ bridge-aggregation [ interface-number ] ] [ |
{ begin | exclude | include } regular-expression ]
reset lacp statistics [ interface interface-list ]
reset counters interface [ bridge-aggregation
[ interface-number ] ]
"Reference
43
Remarks
Available in any view
Available in any view
Available in user
view
Available in user
view
port") can operate as Selected ports.