Configuring The Description Of An Aggregate Interface; Enabling Link State Traps For An Aggregate Interface; Setting The Minimum Number Of Selected Ports For An Aggregation Group - HP A3100-8 v2 SI Configuration Manual

NOTE:
Most configurations that can be performed on Layer 2 Ethernet interfaces can also be performed on Layer
2 aggregate interfaces.

Configuring the description of an aggregate interface

You can configure the description of an aggregate interface for administration purposes, such as
describing the purpose of the interface.
Follow these steps to configure the description of an aggregate interface:
To do...
Enter system view
Enter Layer 2 aggregate
interface view
Configure the description of the
aggregate interface

Enabling link state traps for an aggregate interface

You can configure an aggregate interface to generate linkUp trap messages when its link goes up and
linkDown trap messages when its link goes down. For more information, see the Network Management
and Monitoring Configuration Guide.
Follow these steps to enable link state traps on an aggregate interface:
To do...
Enter system view
Enable the trap function
globally
Enter Layer 2 aggregate
interface view
Enable link state traps for the
aggregate interface
Setting the minimum number of Selected ports for an
aggregation group
The bandwidth of an aggregate link increases along with the number of selected member ports. To avoid
congestion caused by insufficient Selected ports on an aggregate link, you can set the minimum number
of Selected ports required for bringing up the specific aggregate interface.
Use the command...
system-view
interface bridge-aggregation
interface-number
description text
Use the command...
system-view
snmp-agent trap enable [ standard
[ linkdown | linkup ] * ]
interface bridge-aggregation
interface-number
enable snmp trap updown
35
Remarks
—
—
Optional
By default, the description of an
interface is interface-name Interface,
such as Bridge-Aggregation1 Interface.
Remarks
—
Optional
By default, link state trapping is
enabled globally and on all
interfaces.
—
Optional
Enabled by default.