Assigning A Hybrid Port To A Vlan - HP 6125G Configuration Manual

Step
2. Enter
interface
view.
3. Configure the
link type of
the ports as
trunk.
4. Assign the
trunk ports to
the specified
VLANs.
5. Configure the
PVID of the
trunk ports.
NOTE:
After configuring the PVID for a trunk port, you must use the port trunk permit vlan command to configure
the trunk port to allow packets from the PVID to pass through, so that the egress port can forward packets
from the PVID.

Assigning a hybrid port to a VLAN

A hybrid port can carry multiple VLANs. You can assign it to a VLAN in interface view (including Ethernet
interface view, and Layer 2 aggregate interface view).
To assign a hybrid port to one or multiple VLANs:
Step
1. Enter system
view.
Command
•
Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
•
Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
port link-type trunk
port trunk permit vlan { vlan-list | all }
port trunk pvid vlan vlan-id
Command
system-view
Remarks
Use any command.
•
The configuration made in Layer 2 Ethernet
interface view applies only to the port.
•
The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply the
configuration to the aggregate interface, it
stops applying the configuration to
aggregation member ports. If the system
fails to apply the configuration to an
aggregation member port, it skips the port
and moves to the next member port.
By default, all ports are access ports.
To change the link type of a port from trunk to
hybrid or vice versa, you must set the link type
to access first.
By default, a trunk port carries only VLAN 1.
Optional.
By default, the PVID is VLAN 1.
Remarks
N/A
107