RayTek MI3 Operating Instructions Manual page 35

Consider the following sequence for the installation:
1.
2.
3.
MI3
info@Raytek-Direct.ca
Disconnect/reconnect the USB interface cable to the computer!
Ignore the Windows Wizard <Found New Hardware>!
Navigate manually to the dedicated USB driver <RaytekMIcomport.inf> on the support media
and execute it.
It is strongly recommended to check the correct driver installation under the Windows
Operating System <Start> <Settings> <Control Panel> <System> <Hardware> <Device
Manager> <Ports (COM & LPT)>. Go there also to get the virtual COM port number for
communicating with the DTMD Software.
Rev. F1 05/2013
Installation
Driver correctly installed!
COM port number
for DTMD Software!
35
1.800.868.7495