GE VAT200 Quick Start Manual page 94

Errors which can be recovered manually and automatically
Display Error
Over current at
OC-S
start
Over-current at
OC-D
deceleration
Over-current at
OC-A
acceleration
Over-current at
OC-C
fixed speed
Voltage too high
OV-C
during operation/
deceleration
Illegal interrupt
Err4
of CPU
Over speed during
operating
OVSP
Cause
1. the motor wind and
enclosure short circuit
2. the motor contacts and earth
short circuit
3. the IGBT module ruined
The preset deceleration time is
too short.
1. Acceleration time too short
2. The capacity of the
motor higher than the
capacity of the inverter
3. Short circuit between
the motor coil and the
shell
4. Short circuit between
motor wiring and earth
5. IGBT module damaged
1. Transient load change
2. Transient power change
1. Deceleration time setting too
short or large load inertia
2. Power voltage varies widely
Outside noise interference
1. Moter load too big or Inverter
capacity too small
2. Moter parameter error
(vector mode)
3. The gain is too big during
vector mode operating
4. The Current detect circuit
fault
5-2
Chapter 5 Troubleshooting and maintenance
Remedy
1. inspect the motor
2. inspect the wire
3. replace the transistor module
Set a longer deceleration time
1. Set a longer acceleration time
2. Replace a inverter with the
same capacity as that of the
motor
3. Check the motor
4. Check the wiring
5. Replace the IGBT module
1.Increase the capacity of the
inverter
2.Rerun parameter auto tuning
(0-06 = 1)
3. Reduce stator resistance (14-0)
if the above remedies are
helpless
1. Set a longer deceleration time
2. Add a brake resistor or brake
module
3. Add a reactor at the power input
side
4. Increase inverter capacity
Send back to repair if it happens
many times
1. Increase acceleration /
deceleration time (3-02/3-03)
2. Input correct motor
Parameter
3.Change stator Resistance gain
and Rotator resistance gain
(14-0/14-1), suggest that
decrease 50~100, until 0
4. Send back to GE