Ethernet Communications - Intermec 700 Series User Manual

Chapter 4 — Network Support

Ethernet Communications

86
Follow the steps below to start Ethernet communications on the 700 Series
Computer. If your system does not contain an 802.11b radio, then
Ethernet networking using DHCP will be selected as the default.
When "Built-in Ethernet" is selected from the NDISTRY pop-up menu,
then the antenna shown to the left will appear in the System Tray. When
"No networking" is selected, then this icon will appear with a red "X"
above it.
From the 700 Series Computer, tap Start → Settings → the Connections
tab → Network Adapters to access the network connections for this unit.
Make the changes necessary for your network, then tap ok when finished.
Note: "LAN9000" is for Ethernet and "802.11b Wireless LAN" is for
802.11b radios.
700 Series Color Mobile Computer User's Manual