Intermec 700 Series User Manual page 330
Color mobile computer
Hide thumbs
Also See for 700 Series:
- User manual (480 pages) ,
- Quick start manual (36 pages) ,
- Instructions manual (6 pages)
Table of Contents
Advertisement
Action: Tap (+) to expand the Symbology ID parameter, select the Code 93 user
SNMP OID: 1.3.6.1.4.1.1963.15.3.3.4.1.4.1
Options: x
Action: Tap (+) to expand the Symbology ID parameter, select the Interleaved 2
SNMP OID: 1.3.6.1.4.1.1963.15.3.3.4.1.10.1
Options: x
Action: Tap (+) to expand the Symbology ID parameter, select the PDF 417 user
SNMP OID: 1.3.6.1.4.1.1963.15.3.3.4.1.12.1
Options: x
Action: Tap (+) to expand the Symbology ID parameter, select the MSI user ID
SNMP OID: 1.3.6.1.4.1.1963.15.3.3.4.1.11.1
Options: x
700 Series Color Mobile Computer User's Manual
Code 93 User ID
If "1" was selected in the Symbology ID parameter, you can set your own
ASCII character to identify Code 93 bar code data. Note that this is not
available when you use an imager with your 700 Series Computer.
ID parameter, then enter a user ID value to change this parameter setting.
where x is a single ASCII character. Default is asterisk (*).
Interleaved 2 of 5 User ID
If "1" was selected in the Symbology ID parameter, you can set your own
ASCII character to identify Interleaved 2 of 5 bar code data. Note that this
is not available when you use an imager with your 700 Series Computer.
of 5 user ID parameter, then enter a user ID value to change this parame-
ter setting.
where x is a single ASCII character. Default is I (not lowercase L).
PDF-417 User ID
If "1" was selected in the Symbology ID parameter, you can set your own
ASCII character to identify PDF 417 bar code data. Note that this is not
available when you use an imager with your 700 Series Computer.
ID parameter, then enter a user ID value to change this parameter setting.
where x is a single ASCII character. Default is an asterisk (*).
MSI User ID
If "1" was selected in the Symbology ID parameter, you can set your own
ASCII character to identify MSI bar code data. Note that this is not avail-
able when you use an imager with your 700 Series Computer.
parameter, then enter a user ID value to change this parameter setting.
where x is a single ASCII character. Default is D.
Appendix
A
—
Control Panel Applets
311
Advertisement
Table of Contents
