Intermec 700 Series User Manual page 329

Appendix A — Control Panel Applets
Action: Tap (+) to expand the Symbology ID parameter, select the Code 39 user
SNMP OID: 1.3.6.1.4.1.1963.15.3.3.4.1.3.1
Options: x
Action: Tap (+) to expand the Symbology ID parameter, select the Code 128 user
SNMP OID: 1.3.6.1.4.1.1963.15.3.3.4.1.5.1
Options: x
Action: Tap (+) to expand the Symbology ID parameter, select the Codabar user
SNMP OID: 1.3.6.1.4.1.1963.15.3.3.4.1.2.1
Options: x
310
Code 39 User ID
If "1" was selected in the Symbology ID parameter, you can set your own
ASCII character to identify Code 39 bar code data. Note that this is not
available when you use an imager with your 700 Series Computer.
ID parameter, then enter a user ID value to change this parameter setting.
where x is a single ASCII character. Default is asterisk (*).
Code 128 User ID
If "1" was selected in the Symbology ID parameter, you can set your own
ASCII character to identify Code 128 bar code data. Note that this is not
available when you use an imager with your 700 Series Computer.
ID parameter, then enter a user ID value to change this parameter setting.
where x is a single ASCII character. Default is asterisk (*).
Codabar User ID
If "1" was selected in the Symbology ID parameter, you can set your own
ASCII character to identify Codabar bar code data. Note that this is not
available when you use an imager with your 700 Series Computer.
ID parameter, then enter a user ID value to change this parameter setting.
where x is a single ASCII character. Default is D.
700 Series Color Mobile Computer User's Manual