Is9Cconfig::setcode39; Code 39 Default Settings - Intermec 700 Series User Manual

Parameter
Decoding
Format
Start/Stop
Accepted Start/stop Characters * only
Check Digit
Bar Code Length
700 Series Color Mobile Computer User's Manual

IS9CConfig::SetCode39

This function updates the Code 39 settings with new values.
Syntax
HRESULT IS9CConfig::SetCode39( ITC_CODE39_DECODING
eDecode,ITC_CODE39_FORMAT eFormat, ITC_CODE39_START_STOP
eSS,ITC_CODE39_SS_CHARS eSSChars, ITC_CODE39_CHECK_DIGIT
eCheck, DWORD dwLength );
Parameters
eDecode [in] Identifies the decoding for Code 39.
eFormat [in] Identifies the Code 39 Format.
eSS [in] Identifies the Start/Stop option.
eSSChars [in] Identifies the Start/Stop character.
eCheck [in] Identifies the Check digit.
dwLength [in] Identifies the bar code length.
Return Values
HRESULT that indicates success or failure.
Remarks
None.
See Also
None.

Code 39 Default Settings

Default
Active
Standard 43 Character ITC_CODE39_FORMAT
Not Transmitted
Not Used
Any Bar Code Length
Chapter
Valid Range
ITC_CODE39_DECODING
ITC_CODE39_START_STOP
ITC_CODE39_SS_CHARS
ITC_CODE39_CHECK_DIGIT
0x00`0xFE ITC_BC_LENGTH_NO_CHANGE
6 — Scanner Support
177