Confirming Call Disconnections - RADVision Scopia XT Executive User Manual

Step 3
Step 4

Confirming Call Disconnections

To prevent accidental disconnection from a call, you can configure the system to confirm
before a call is disconnected. By default, calls are disconnected when a participant ends the
call, without requiring a confirmation.
You can perform this procedure with your XT Remote Control Unit as described below, or
using your keyboard and mouse (for more information, see
Control the Scopia XT Executive" on page
Procedure
Step 1
Step 2
Step 3
RADVISION | User Guide for Scopia XT Executive Version 3.1.1
in a call and accept an incoming call, the built-in MCU is activated, adding the caller to a
videoconference.
(Optional) Enter the number of rings in the Answer after (Rings) list to specify after how
many rings the system accepts a call. This option is relevant only if automatic answering is
enabled.
From the web interface only, select Save.
Access the call settings, as follows:
•
From the XT Series web interface, select Basic Settings > Call-Answer Mode > General.
•
From the endpoint's main menu, select Configure > Calling.
Figure 5-3
Set Confirm Disconnect to Yes.
From the web interface only, select Save.
21).
Calling preferences
"Using the Keyboard and Mouse to
Customizing Your User Experience | 77