Mitsubishi Electric MELSEC-L Special Instructions Manual page 137

Setting data
Device Item
(s1)[0] Execution/Error
completion type
Setting data
...
b15 b7
0 (2)
Execution type (bit 0)
■Ethernet
0: Without arrival confirmation
• When the target station is on the same network
Completed when data are sent from the host station.
Completed
Execution source Target station
• When the target station is on another network
Completed when data reach to a relay station on the same network.
Completed
Relay station
Execution source
1: With arrival confirmation
Completed when data are written to the target station.
Completed
Target station Execution source
■MELSECNET/HCC-Link IE
0: Without arrival confirmation
• When the target station is on the same network
Completed when data are sent from the host station.
Request source Target station
Completed
• When the target station is on another network
Completed when data reach to a relay station on the same network.
Request source Relay station
Completed
1: With arrival confirmation
Completed when data are written to the target station.
Request source Relay station
Completed
Target station
When '0: Without arrival confirmation' is specified, even if writing to the target station is
completed abnormally in the following cases, the processing of the instruction in the
host station is completed normally.
• Communication itself was completed normally, although the sent data were
erroneous.
• Data could not be written to the target station because instructions from multiple
stations were executed to the same station. (An error code (F222H, E006H, E205H,
D202H, or D282H) is detected at the target station.)
...
b0
0 (1)
Target station
Relay station
Target station
Completed
Target station
Completed
Target station
5 MODULE DEDICATED INSTRUCTION
5.4 Network Dedicated Instruction
Setting Setting
range side
0000H, User
0001H,
0080H,
0081H
5
135