Using The Mounting Holes On Top Of The Base (Sa5C, Sa6C, Sa7C) - IAI ROBO Cylinder RCP2 Series Operating Manual

5.3.2

Using the Mounting Holes on Top of the Base (SA5C, SA6C, SA7C)

As for mounting bolts, use hexagon socket-head bolts conforming to the applicable specification in the table
below in accordance with the machine frame material.
When the mating material is
Type
steel
SA5C M4 × 10
SA6C M4 × 10
SA7C M5 × 10
Note: When reinstalling the side covers, do not let them contact the end faces of the stainless sheet.
This may damage or bend the stainless sheet, causing the sheet to deteriorate or wear quickly.
Therefore, install the side covers and check for bending according to the procedure below.
[1] To prevent the side covers from contacting the
end faces of the sheet, insert a shim (approx.
0.1 to 0.2 mm) between the sheet and each
cover to provide a slight allowance, and gently
push in the cover.
[3] Finally, move the slider back and forth several times along the entire stroke to check that the slider does not
contact the sheet.
Through holes are provided in the base for installing the
actuator on its top face.
When installing the actuator, remove the side covers.
(Remove the two thin-head screws [M3 x 6 mm] for mounting
the cover using an Allen wrench of 1. 5 mm across flats.)
When securing with bolts, protect the stainless sheet from
dents or damage by making sure not to drop bolts or tools
onto the stainless sheet or contact them with it.
When the mating material is
aluminum
M4 × 15
M4 × 15
M4 × 15
[2] Remove the slider covers and check to see that
the right and left clearances between the slider
and sheet are nearly equal and no bending is
created.
Slider
Mounting Hole (Reference)
4.5 drill, 8 counterbore depth 4.5
4.5 drill, 8 counterbore depth 4.5
6 drill, 9.5 counterbore depth 5.5
Sheet
Right and left clearances
are nearly equal
39