Installation - IAI ROBO Cylinder RCP2 Series Operating Manual

5. Installation

The method to install your actuator in a mechanical system is explained.
5.1 Installation
Install the actuator as explained below, as a rule.
Pay attention to these items when installing the actuator (except for custom-order models).
: Installable : Daily inspection is required x: Not installable
Horizontal
installation
Installation postures
H o z i r o t n l a
When the unit is installed vertically oriented, attempt to put the motor up unless there is a
Caution: 1.
special reason. Putting the motor on the lower side would not cause a problem in an
ordinary operation. However, it may rarely cause a problem, when it is not operated for a
long period, depending on the surrounding environment (especially high temperature),
caused by the grease being separated and the base oil flowing into the motor unit.
2. The clean room types listed below cannot be guaranteed to meet Cleanliness Class 10 if
they are installed in the vertical orientation, the horizontally wall mounted orientation or in the
ceiling mounted orientation since they do not possess a structure to grip the stainless steel
sheet from the side cover.
Please contact us if it is necessary to install the following models in an orientation other than
the horizontal orientation.
Actuator Model : RCP2CR-SA5C, RCP2CR-SA6C
3. Can be installed sideways or ceiling mount, but the actuators must be checked daily.
If the actuator is installed sideways or ceiling mount, the stainless sheet may be slacked or
displaced. If the actuator is used continuously while the stainless sheet is slacked or
displaced, the stainless sheet may break or other problems may occur. Check the actuator
daily and if the stainless sheet is found slacked or displaced, make installation adjustment
of the stainless sheet. [Refer to 9,8 "Replacing/Adjusting the Stainless Sheet." ]
36
Vertical
installation
S d i e
V r e c i t l a
Ceiling mount
Sideway
installation
installation
w a y Ceiling mount