Reference Surface And Mounting Surface - IAI ROBO Cylinder RCP2 Series Operating Manual

5.5

Reference Surface and Mounting Surface

• The mounting table should have sufficient rigidity to avoid generating vibration.
• The surface where the actuator will be mounted should be machined or be equally level and the flatness
tolerance between the actuator and the table should be within 0.05 mm.
• Provide sufficient space around the actuator to permit maintenance work to be performed.
• The side and bottom faces of the actuator base provide the reference planes for slider travel.
• When traveling precision is required, use these surfaces as the reference planes for mounting.
Reference plane
(Side face of the base)
Caution: As shown above, the side faces of the base provide the reference planes for slider travel.
When precision is required, use these surfaces as the reference planes for mounting.
When using the base as the reference planes for mounting the actuator to the machine frame, follow the
machining dimensions shown below.
R0.3 or less
Reference plane
(Side face of the base)
Model Dimension A (mm)
SA5C
SA6C
SA7C
SS7C
SS8C
HS8C
2 to 3.5
2 to 3.5
2 to 5
2 to 5
2 to 5
2 to 5
41