Table of Contents
Advertisement
FreewayRange
Pro-Bel ltd
The source name displayed is for the sour ce routed to the destination of the first
level assigned in the destination association.
When display AUO parameters is enabled for the UMO then the 13th character of
the display is used to indicate the combined source and destination audio
parameter for the most significant active Analogue Audio level configured.
The source name is displayed in the first 8 characters. See Panels with displays
section for definition of
symbols
used.
To assign destination associations to the UMO a destination
keypad
must first be
set up using the 'KO' command and then assigned to the UMO using the 'PT'
command. The 'PT' command also assigns the UMO to a panel position on a chain .
• 7.S Configuration via panels
This section details the operation
of:
Type 3 Normal 6276
X-Y;
Type 4 Generic
Multi-Output
and
Type
3
6276 X-Y
Master panels with regards to
:
assignment of
audio parameters for Analogue Audio sources and destinations
;
assignment of
trigger type to sources.
The four special function buttons is assignable.
Two new special function buttons is required:
•
<DISPLAY
AUDIO>
enable/disable display of AUO parameter indication.
•
<CONFIG AUDIO>
enable/disable
configuration of AUO parameters
Common rules
While con fig AUO parameters is enabled then only AUD parameters can be
pre
selected (i.e. sources and d
estinations
cannot be dialled up)
.
Pressing
<CLEAR>,
while in this mode, will result in the displays showing what was displayed on
entry.
If the display audio parameters function is disabled then full 8
character
names
will be displayed with no AUO parameter, even if the first level is
Freeway
Analogue Audio.
Selecting display audio function results in the 8th character of the
displays
showing th
e
AUO
parameter
assign
ed
for the most signifi
cant active
level with
AUO parameters enabl
ed.
6540T-00 Nov 97
86
Advertisement
Table of Contents
