pro bel Freeway Manual page 82

Freeway Range
Pro-Bel
ltd
<PROTECT>, <INCREMENT> and <DECREMENT> can also be assigned to the keypad
buttons.
<CLEAR> is dedicated to the bottom right button of the keypad.
The STATUS display shows the source routed for the most significant active level.
<PROTECT> does not require an LED button. Setting a destination protected is
described below:
1 Dial-up a destination
2 Press <PROTECT>. PROTECT? will flash in PRESET display to indicate
destination will be protected on a TAKE
3 Press <TAKE>. The destination is protected. PRESET display reverts to
showing what was displayed previously.
Type 3 panels can be defined, via editors, to work in Panel swap mode . When the
take button is pressed the previously routed sources are exchanged with the pre ­
selected source association. The Preset display will be updated to show the
previously routed sources (on active levels only) .
On stereo analogue audio levels , with the audio parameter feature enabled, the
source name is limited to the first 7 characters on PRESET and STATUS displays.
The eighth character gives an indication of the audio parameter configured for the
source as defined in the table. in the Panels with displays section. This is also
applicable to the DESTINATION display where the eighth character gives an
indication of the audio parameter configured for the destination displayed in the
first 7 characters.
On left hand side of the DESTINATION display is an amber LED which when ON
indicates that the sources routed to the destination association selected are an
UNMARRIED combination.
These panels can be designated Master and can be used to configure AUD
parameters for sources and destinations . See Configuration via panels section for
details.
There are no override inputs associated with this type of panel.
6540T-00 Nov 97 82