Controller Configuration - pro bel Freeway Manual

Freeway Ra nge
Pro-Bel ltd
• 4.3 Controller configuration
The controller has provision for configuration. There exists an editor port, and an
8-way piano key switch to support a configurable system.
Editor port
This is an RS232 port connected to a simple PC based editor. (See Salvos section
for more details.)
Configurable switches
The function of each of the switches located on the 2440 are defined in the table
below.
Switch
Function Selection
Default
UP DOWN
1 MASTER/SLAVE SELECT SLAVE MASTER DOWN
2 I-lP CLOCK SELECT 10 MHz 20 MHz DOWN
3 SYSTEM RUN MODE NORMAL
TEST
UP
4 RS232 PORT SELECT EDITOR REMOTE UP
5 DEFAULT TRIGGER
SELECT
625 525 UP
6 RE-CONFIGURE MANUAL AUTO UP
7
DATABASE TYPE FIXED CONFIGURE UP
8 CONTROL MODE GENERAL PANELS
UP
A description of the function of each of the switches is given below:
sw2_1 Master/Slave select is used , in dual control situations, to assign
Master/Slave status to the 2440 control cards. One card would be set to MASTER
and the other to SLAVE so that on reset or power up the Master 2440 powers up
first and, hence, always becomes the active controller.
6540T-00 Nov 97 38