Table of Contents
Advertisement
Freeway
Range
Pro-Bel Ltd
The pressed button will either illuminate if it has a valid associated destination
association index, or have alphanumeric displays to show the name of the
selected destination association.
On power-up no destination button is selected so all destination buttons are
extinguished and any destination displays on X-V panels are blanked
.
Source buttons
Button per
source
type keypads and dial up keypads are available.
Pressing a source button or a sequence of these buttons, routes sources on the
active and controllabl
e levels only.
The source buttons on some
panels
are used to preselect sources not route them.
These panels have <TAKE> buttons to make the selections.
Panel swap mode
Panel Swap Mode is a panel assignable feature which swaps pre-select and source
routed on <TAKE>, otherwise the pre-select does not change.
Display AUD parameters
Thi
s
is an assignable feature to the
s
pecial function buttons on type 3 and 4
panels only. When enabled this feature displays source and destination AUD
parameters in the eighth character of the displays for the most significant stereo
Analogue
Audio
level
in the system.
Configure AUD parameters
This is an assignable feature to the special function buttons on type 3 and 4
panels only. When enabled this feature allows
pre-selection
of destination AUD
parameters for stereo analogue audio lev
els.
If panel is
a
Master 6276
X-V
then
enabling this feature allows AUD parameters to be ass igned to sources and
destinations and allows trigger type to be assigned to sources. Enabling this
feature automaticall
y
enables the
display
AUD parameters feature.
Override inputs
Some panels allow a number of
override
input
s
to
momentarily override
the
current source routed to a destination with another source.
6540T-00 Nov 97
68
Advertisement
Table of Contents
