Configuring Through Telnet - 3Com Switch 7700 Configuration Manual

8 C 1: S A
HAPTER YSTEM CCESS
Configuring Through
Telnet
Figure 6 Settings Tab
Setting the Terminal Parameters is described in the following sections:

Configuring Through Telnet

■
Configuring Through a Dial-up Modem
■
Configuring the User Interface
■
Before you can telnet to a Switch 7700 and configure it, you must:
1 Configure the IP address of a VLAN interface for the Switch 7700 through the
console port (using the ip address command in VLAN interface view)
2 Add the port (that connects to a terminal) to this VLAN (using the port command
in VLAN view)
3 Log in to the Switch 7700
Tasks for Configuring through Telnet are described in the following sections:
Connecting the PC to the Switch 7700
■
Connecting Two Switch 7700 Systems
■