Daikin E-Series Service Manual page 296

SiAU18-715
1. Open the suction grille.
Slide both knobs simultaneously as shown and
then pull them downward.
(Do the same procedure for closing.)
(Refer to Fig.1)
(If chains are present. Unhook the chains.)
(Refer to Fig.2)
2. Remove the air filters.
Remove the air filters by pulling its cloth forward.
(Refer to Fig.3)
3. Clean the air filter.
Use vacuum cleaner A) or wash the air filter with
water B).
A)Using a vacuum cleaner
B)Washing with water
When the air filter is very
dirty, use soft brush and
neutral detergent.
Remove water and dry in the shade.
Operation Manual
Fig. 1
Fig. 2
Fig. 3
NOTE
• Do not wash the air conditioner with hot water of
more than 50°C, as doing so may result in discol-
oration and/or deformation.
• Do not expose it to fire, as doing so may result in
burning.
4. Fix the air filter.
Align the two hangers and push the air filter up.
Confirm that four hangers are fixed.
(Refer to Fig.4)
Fig. 4
5. Close the suction grille.
Refer to item No. 1.
6. After turning on the power, press FILTER
SIGN RESET button.
The display " "(TIME TO CLEAN AIR FIL-
TER) vanishes.
HOW TO CLEAN AIR OUTLET, SUCTION
GRILLE AND OUTSIDE PANELS
• Clean with soft cloth.
• When it is difficult to remove stains, use water or
neutral detergent.
• Clean the suction grille when it is shut.
NOTE
• Do not use gasoline, benzene, thinner, polishing
powder, liquid insecticide. It may cause discolor-
ing or warping.
• Do not let the indoor unit get wet. It may cause an
electric shock or a fire.
• Do not use water or air of 50°C or higher for clean-
ing air filters and outside panels.
START UP AFTER A LONG STOP
Confirm the following
• Check that the air inlet and outlet are not blocked.
Remove any obstacle.
• Check if the earth is connected.
Might there be a broken wire somewhere?
Contact your dealer if there are any problems.
Instruction
283