Daikin E-Series Service Manual page 279

Instruction
1. WHAT TO DO BEFORE
OPERATION
This operation manual is for the system with stan-
dard control. Before initiating operation, contact
your Daikin dealer for the operation that corre-
sponds to your system.
NOTE
• If the unit you purchased is controlled by a wire-
less remote controller, also refer to the wireless
remote controller's operation manual.
If your installation has a customized control system,
ask your Daikin dealer for the operation that corre-
sponds to your system.
• Heat pump type
This system provides cooling, heating, automatic,
program dry, and fan operation modes.
• Cooling only type
This system provides cooling, program dry, and
fan operation modes.
266
PRECAUTIONS FOR GROUP CONTROL
SYSTEM OR TWO REMOTE CONTROL-
LERS CONTROL SYSTEM
This system provides two other control systems
beside individual control (one remote controller con-
trols one indoor unit) system. Confirm the following if
your unit is of the following control system type.
• Group control system
One remote controller controls up to 16 indoor
units.
All indoor units are equally set.
• Two remote controllers control system
Two remote controllers control one indoor unit (In
case of group control system, one group of indoor
units)
The unit is individually operated.
NOTE
• Contact your Daikin dealer in case of changing
the combination or setting of group control and
two remote controllers control system.
Names and functions of parts
Refer to figure 2 on page [1]
a Indoor unit
b Remote controller
c Inlet air
d Discharge air
e Air outlet
f Air flow flap (at air outlet)
g Refrigerant piping, connection electric wire
h Drain pipe
Air inlet
i
The built-in air filter removes dust and dirt.
Drain pumping out device(built-in)
j Condensate removed from the room during
cooling.
SiAU18-715
Operation Manual