Daikin E-Series Service Manual page 218

SiAU18-715
To use ON TIME R operation
• Check that the clock is correct. If not, set
the clock to the present time
1. Press "ON TIMER button".
is displayed.
blinks.
2. Press "TIMER Setting button"
until the time setting reaches
the point you like.
• Every pressing of either button
increases or decreases the time setting
by 10 minutes. Holding down either but-
ton changes the setting rapidly.
3. Press "ON TIMER button"
again.
• The TIMER lamp lights up.
To cancel ON TI MER
operation
4. Press "CANCEL button".
• The TIMER lamp goes off.
To combine ON TI MER and OFF TI MER
• A sample setting for combining the two timers is shown below.
ATTENTION
In the following cases, set the timer again.
• After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote controller.
Operation Manual
ECONO
ON/OFF
TEMP
POWERFUL
MODE FAN SWING
QUIET MOLD PROOF SENSOR
ON CANCEL
OFF
TIMER
Instruction
1, 3
4
2
205