Daikin E-Series Service Manual page 240

SiAU18-715
Outdoor Unit
19
Indoor Unit
1. Titanium Apatite Photocatalytic
Air-Purifying Filter:
• These filters are attached to the inside of
the air filters.
2. Air outlet
3. Display
4. Front panel
5. Louvers (vertical blades): (page 12.)
• The louvers are inside of the air outlet.
6. Air inlet
7. Air filter
8. Flap (horizontal blade): (page 12.)
9. Operation lamp (green)
10. TIMER lamp (yellow): (page 17.)
11. Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
Outdoor Unit
15. Air inlet: (Back and side)
16. Refrigerant piping and inter-unit cable
17. Drain hose
Appearance of the outdoor unit may differ from some models.
Operation Manual
15
12. Signal receiver:
13. Air outlet selection switch: (page 13.)
14. Room temperature sensor:
18. Earth terminal:
19. Air outlet
• The operation mode refers to the following
table.
Temperature
Mode
setting
22˚C
COOL
AUTO 25˚C
• This switch is useful when the remote
controller is missing.
• It receives signals from the remote
controller.
• When the unit receives a signal, you will
hear a short beep.
• Operation start ........ beep-beep
• Settings changed ..... beep
• Operation stop.......... beeeeep
• It senses the air temperature around the unit.
• It is inside of this cover.
Instruction
16
17
18
Air flow rate
AUTO
AUTO
5
227