Daikin E-Series Service Manual page 171

Field Setting for SkyAir Indoor Unit
Address Setting <Setting from the remote controller>
1. Hold down the "
(It is Factory Set
to "1")
2. Press the "
3. Press the "
4. Press the "
5. Hold down the "
Multiple Settings When the indoor is being operating by outside control (central remote controller, etc.), it
sometimes does not respond to ON/OFF and temperature setting commands from this remote
A/b
controller. Check what setting the customer wants and make the multiple setting as shown
below.
Multiple Setting
A: Standard
b: Multiple display
158
" button and the "
the FIELD SET MODE. (Indicated in the display area in the figure at below).
" button and select a multiple setting (A/b). Each time the button is
pressed the display switches between "A" and "b".
" button and "
Address can be set from 1 to 6, but set it to 1 ~ 3 and to same address as the receiver. (The
receiver does not work with address 4 ~ 6.)
" button to enter the setting.
return to the normal display.
Remote Controller
Remote Controller
Display
All items Displayed.
Operations set only is
displayed shortly after
execution.
" button to set the address.
" button for at least 1 second to quit the FIELD SET MODE and
Controlled by other Air
Conditioners and
Devices
Commands other than
ON/OFF and
Temperature Setting
Accepted. (1 LONG
BEEP or 3 SHORT
BEEPS Emitted)
All Commands Accepted (2 SHORT BEEPS)
" button for at least 4 seconds, to get
Indoor Unit
For other than on Left
Test Operation
SiAU18-715