Daikin E-Series Service Manual page 284

SiAU18-715
Press the AIR FLOW DIRECTION ADJUST
button to select the air direction as shown
below.
swing
Press AIR FLOW DIRECTION
ADJUST button to select the air
direction of your choice.
MOVEMENT OF THE AIR FLOW FLAP
For the following conditions, micro computer con-
trols the air flow direction so it may be different from
the display.
Operation
Cooling
mode
• When room
temperature is
lower than the
Operation set temperature
condition • When operating
continuously at
horizontal air
flow direction
Operation mode includes automatic operation.
PROGRAM TIMER OPERATION
Operate in the following order.
• The timer is operated in the following two ways.
• Programming the stop time (
tem stops
operating after the set time has elapsed.
• Programming the start time (
tem starts
operating after the set time has elapsed.
• The timer can be programmed a maximum of
72 hours.
• The start and the stop time can be simultaneously
programmed.
Operation Manual
The AIR FLOW FLAP display
swings as shown below and
the air flow direction continu-
ously varies. (Automatic swing
setting)
The AIR FLOW FLAP display
stops swinging and the air flow
direction is fixed (Fixed air flow
direction setting).
Heating
• When room
temperature is
higher than the
set temperature
• At defrost opera-
tion
) .... The sys-
) .... The sys-
1
TIMER MODE START/STOP
Press the TIMER MODE START/STOP button
several times and select the mode on the
display.
The display flashes.
For setting the timer stop .... "
For setting the timer start .... "
2
PROGRAMMING TIME
Press the PROGRAMMING TIME button and
set the time for stopping or starting the sys-
tem.
When this button is pressed, the time
advances by 1 hour.
When this button is pressed, the time
goes backward by 1 hour.
3
TIMER ON/OFF
Press the TIMER ON/OFF button.
The timer setting procedure ends.
The display " or
ing light to a constant light.
Refer to figure 4 on page [1]
NOTE
• When setting the timer Off and On at the same
time, repeat the above procedure from
once again.
When the timer is programmed to stop the system
after 3 hours and start the system after 4 hours, the
system will stop after 3 hours and then 1 hour later
the system will start.
• After the timer is programmed, the display shows
the remaining time.
• Press the TIMER ON/OFF button once again to
cancel programming. The display vanishes.
7. OPTIMUM OPERATION
Observe the following precautions to ensure the
system operates.
• Adjust the room temperature properly for a com-
fortable environment. Avoid excessive heating or
cooling.
• Prevent direct sunlight from entering a room dur-
ing cooling operation by using curtains or blinds.
Instruction
"
"
" changes from flash-
to 3
1
271