Daikin E-Series Service Manual page 268

SiAU18-715
1. WHAT TO DO BEFORE
OPERATION
This operation manual is for the following systems
with standard control. Before initiating operation,
contact your Daikin dealer for the operation that
corresponds to your sysem.
• Pair system
Outdoor unit
Unit with
remote
controller
• Multi system
Indoor unit
Outdoor unit
Unit with
remote
controller
NOTE
• If the unit you purchased is controlled by a wire-
less remote controller, also refer to the wireless
'
remote controller s operation manual.
If your installation has a customized control system,
ask your Daikin dealer for operation that corre-
sponds to your system.
Operation Manual
Indoor unit
Indoor unit
Unit with
remote
controller
• Heat pump type
This system provides cooling, heating, automatic,
program dry, and fan operation modes.
• Cooling only type
This system provides cooling, program dry, and
fan operation modes.
PRECAUTIONS FOR GROUP CONTROL
SYSTEM OR TWO REMOTE
CONTROLLER CONTROL SYSTEM
This system provides two other control systems
beside individual control (one remote controller
controls one indoor unit) system. Confirm the fol-
lowing if your unit is of the following control system
type.
• Group control system
One remote controller controls up to 16 indoor
units.
All indoor units are equally set.
• Two remote controllers control system
Two remote controllers control one indoor unit
(In case of group control system, one group of
indoor units)
The unit is individually operated.
NOTE
• Contact your Daikin dealer in case of changing
the combination or setting of group control and
two remote controllers control system.
Names and functions of parts
Refer to figure 2 on page
Indoor unit
a
Outdoor unit
• The external appearance of the outdoor
unit varies depending on its capacity
class. The outdoor unit shown in the fig-
b
ure is for reference to indicate features.
Contact your Daikin Dealer and verify
which outdoor unit you have.
c Remote controller
Inlet air
d
e Discharged air
Air outlet
f
Air flow flap (at air outlet)
g
h Refrigerant piping, connection electric wire
Drain pipe
i
Air inlet
j
The built-in air filter removes dust and dirt.
Drain pumping out device (built-in)
Drains water removed from the room dur-
k
ing cooling.
Ground wire
Wire to ground from the outdoor unit to pre-
l
vent electrical shocks.
Instruction
[1]
255