Hitachi UX Twin Nozzle Service Manual page 12

SAFETY PRECAUTIONS (Continued)
Main Body Handling
● Do not insert tweezers, a screwdriver, or any other metal article
into the ink ejection hole in the end of the print head.
When the printer is ready to print, a high voltage (approximately 6 kV) is applied to
the deflection electrode section in the print head.
Exercise caution to avoid electric shock, injury, and fire.
● Exercise caution to avoid inadvertently disconnecting, forcibly
pulling, or bending piping tubes.
Since the ink and makeup in some portions of piping tubes are pressurized, they
may splash into your eyes or mouth or onto your hands or clothing.
If any ink or makeup enters your eyes or mouth, immediately flush with warm or
cold water and consult a physician.
● While the printer is operating, do not look into the ink ejection hole
in the end of the print head.
Ink or makeup may enter your eyes or mouth or soil your hands or clothing.
If any ink or makeup enters your eyes or mouth, immediately flush with warm or
cold water and consult a physician.
● Before servicing the printer, be sure to stop the ink ejection.
Because ink or makeup may splash into your eyes or mouth or onto your hands or
clothing. If any ink or makeup enters your eyes or mouth, immediately flush with
warm or cold water and consult a physician.
● If an earthquake, fire, or other emergency occurs while the printer
is engaged in printing or just turned on, press the Main power
switch to turn off the power.
WARNING
1-6