Rfid Reader - Hitachi UX Twin Nozzle Service Manual

LAN cable connecting
port of LAN Relay
Harness
View from top

3.3.19 RFID reader

[Function]
- Read Ink ID or Makeup ID from IC tag on Ink/Makeup cartridge bottle.
Select Login user ID by reading IC card and register or call the print data.
[Note at the replacement]
- When you replace RFID reader, be sure to turn the main power off.
[Procedures of RFID reader replacement]
(1) Turn off the main power.
(2) Open the control panel.
(3) Remove Protective cover as shown in the drawing below.
Push the Hook of the fixing spacer by finger, and then pull up Protective cover.
(For Two spacers)
Push Hook
Pull up Protective cover
(4) Remove RFID reader harness from CN27 (connector) of EZJ133 board.
EZJ125 board
RFID reader harness
Fixing clamp in I/O Area
3-53
Pull the external LAN cable in through the
port of connection base in the rear and surely
connect it with LAN Relay Harness.
View of I/O Area
Protective cover
Spacer for fixing
protective cover (2 pieces)
EZJ125 board
EZJ133 board
CN27