Hitachi UX Twin Nozzle Service Manual page 130

(5) Peel off Front-Beam sheet.
(6) Unscrew three (3) fixing screws for Front beam, and then remove Front beam.
[Caution] When you remove Front beam, DO NOT pull RFID reader harness by force.
Front-beam sheet
(7) Unscrew two (2) fixing screws for RFID reader cover and remove RFID reader cover.
(8) Pull out RFID-reader harness from connector.
Fixing screws (2 pieces )
for RFID reader cover
RFID reader cover
(9) Replace RFID reader with a new one. Then attach the removed parts in reverse
order of the procedures above.
[Caution] When you attach Front-beam sheet, be sure to follow three (3)
• Replace Front-beam sheet with a new one.
• Confirm that there is NO adhesive remaining on the Front beam.
• Attach the new Front-beam sheet by pushing the Front-beam sheet to
the left side of the convexed frame.
Left side of the convexed frame.
Front beam
When you attach Front beam, be sure that the electrical wires or cables are
NOT to be pinched between any parts.
Front beam
RFID reader harness
points below.
Danger of Electrical shock
3-54
Fixing screws (3 pieces) for Front beam
RFID reader harness
RFID reader cover
RFID reader
Connector
Front-beam sheet