Hitachi UX Twin Nozzle Service Manual page 68

3 Automatic Replenishment data (AUTOSPLY.TXT)
(1) Output contents of Automatic Replenishment data
- Date
- Start time
- Circulation Sequence
- H Initial level
- Mode
- Ambient Temperature
- Machine Inside Temperature
- Ink Pressure 1 and Ink Pressure 2
- Print count
- Dot count
- Ink replenishment (For Dot Count) : Time to replenish ink for "Dot count" (Minute : Second)
- Makeup replenishment (To an initial level)
- Ink replenishment (To an initial level)
- Finish time
- Initial level status
- Result
- Dot count1,2
Interval
(15 minutes)
Step A
<Automatic replenishment sequence processing flow chart>
[Automatic Replenishment data output]
: Date when the Automatic Replenishment was executed
: Time when the Automatic Replenishment started
Norm : Ink concentration is normal
Low : Ink concentration is high
Sequences to reduce the concentration are executed
High : Ink concentration is low
Sequences to increase the concentration are executed
: See the descriptions below.
: Total number of prints when Automatic Replenishment
started
: Number of ink droplets which were used for printing
: Time to replenish makeup to Initial level (Minute : Second)
: Time to replenish ink to initial level (Minute : Second)
: Time when the Automatic Replenishment completed
: Initial level detection when Automatic replenishment started
(0: Not detected; 1: Detected)
: Processing result
Result 0 : Normally completed
Result 1 : Aborted and Skipped
(Note: Ink refill, etc. is saved as "Aborted and Skipped" due to
detection of the initial level of the main ink tank even it is
normally completed.)
Result 2 : Aborted
Result 3 : Completed with failure
: Number of ink droplets which were used for printing by each nozzle
Ink
Viscosity
replenishment
measurement
(for dot count)
Step B Step C1
Makeup
replenishment
Step C2
2-46
Ink
replenishment
(to initial level)
Step C3