6.2.12a (N1)Charge Voltage Fault
(N1)Charge Voltage Fault
Remove the print head cover.
Sprinkle the makeup over Charge
electrode of Nozzle1 and its
neighboring area and clean them.
・ Allow the print head surface
to adequately dry.
・ Clear the fault.
・ Restart the IJ printer.
Does the printer become
ready?
No
Disconnect EZJ125 board
CN4 connector and reconnect it.
Does the printer become
ready?
No
Replace the EZJ125 board*1.
Does the printer become
ready?
No
Replace the EZJ133 board*2.
Does the printer become
ready?
No
Replace the multiple power supply1.
Does the printer become
ready?
No
Replace the print head. *3
(*1): When you replace EZJ125 board, refer to [Replacement
procedures of EZJ125 board] in "3.3.5 EZJ125 board
(Nozzle1 drive board)".
(*2): When you replace EZJ133 board, refer to
procedures of EZJ133 board]
(MPU board)".
(*3): When you replace the printhead, refer to
Replacement Procedure".
[Caution]
Be sure to check that there is no wrong connection of harnesses
by referring to
[Connector numbers and Identifying method of
harnesses]
"3.3.20 Electrical Connection Diagram".
in
Yes
Yes
Yes
Yes
Yes
6-24
[Replacement
in
"3.3.1 EZJ133 board
"4.13 Print Head
END