Hitachi UX Twin Nozzle Service Manual page 13

SAFETY PRECAUTIONS (Continued)
Electrical Parts Handling
● Be sure to shut off the power before replacing electrical
components (power, PC board, etc.). Be sure to unplug the power
cable from the electrical outlet before performing work with the
inlet cover and/or side cover off (terminal block transfer, EZJ113 or
EZJ 139 board replacement, etc.).
Failure to do so could result electrical shock, injury or fire.
● When handling PC boards and electric parts, be careful of static
electricity.
PC boards and electric parts mount elements weak against static electricity.
When handling PC boards and electric parts remove the static electricity by
wearing a suitably grounded anti-static wrist band.
Related Regulations
● Never drain the ink or makeup waste solution into a public sewer
system.
Waste disposal must comply with all appropriate regulations.
Consult the appropriate regulatory agency for further information.
● The printer must be managed in compliance with all appropriate
regulations.
Read and understand the appropriate Safety Data Sheet (SDS) before using any
ink or makeup.
● Ink and makeup must be handled in compliance with the Industrial
Safety and Health Law and PRTR Law (environmental contaminant
discharge/emigration/transfer registration). For information on
handling, see the Safety Data Sheet (SDS). The SDS can be accesses
from the following web site or from our sales office.
URL http://www.hitachi-ies.co.jp/ijp
●The ink and makeup, their waste solution, used wiping papers and
empty containers are flammable. Waste disposal must comply with
appropriate regulations. Consult the appropriate regulatory agency
for further information.
WARNING
CAUTION
WARNING
1-7