YASKAWA Z1000 User Manual page 180

4.13 Advanced Drive Setup Adjustments
n H5-07: RTS Control Selection
Enables or disables RTS control.
Note: Cycle power for the setting to take effect.
No.
H5-07
Setting 0: Disabled. RTS is always on.
Use this setting with point-to-point RS-422 communications.
Setting 1: Enabled. RTS switches while sending.
Use this setting with RS-485 communications or when using multi-drop RS-422 communications.
n H5-08: Communications Protocol Selection
Selects the communications protocol.
No.
H5-08
Setting 0: MEMOBUS/Modbus
Setting 1: N2 (Metasys)
Setting 2: P1 (APOGEE FLN)
Setting 3: BACnet
n H5-09: Communications Fault Detection Time
Sets the time the communications must be lost before the drive triggers a CE fault.
No.
H5-09
n H5-10: Unit Selection for MEMOBUS/Modbus Register 0025H
Sets the unit for the output voltage monitor value in MEMOBUS/Modbus register 0025H.
No.
H5-10 Unit Selection for MEMOBUS/Modbus Register 0025H
Setting 0: 0.1 V units
Setting 1: 1 V units
n H5-11: Communications Enter Function Selection
Selects whether an Enter command is necessary to change parameter values via MEMOBUS/Modbus communications.
to Enter Command on page
No.
H5-11
Setting 0: Enter command necessary
Parameter changes become effective after an Enter command. An Enter command must only be sent after the last parameter
change, not for each single parameter.
180
PLC→Drive
Command message
24 bit length H5-06 setting
Figure 4.33 Drive Transmit Wait Time Setting
Name
RTS Control Selection
Name
Communications Protocol Selection
Name
Communications Fault Detection Time
Name
358.
Name
Communications Enter Function Selection
Drive→PLC
Response message Command message
YASKAWA ELECTRIC TOEP C710616 45F YASKAWA AC Drive – Z1000 User Manual
PLC→Drive
Time
Setting Range
0 or 1
Setting Range
0 to 3
Setting Range
0.0 to 10.0 s
Setting Range
0 or 1
Setting Range
0 or 1
Default
1
Default
0
Default
2.0 s
Default
0
Refer
Default
0