YASKAWA Z1000 User Manual page 179

<1> Default depends on H5-08 setting:
H5-08 = 0, MEMOBUS/Modbus; default: 3
H5-08 = 1, N2 (Metasys); default: 3
H5-08 = 2, P1 (APOGEE FLN); default: 2
H5-08 = 3, BACnet; default: 3
H5-02
<1>
0
<1>
1
2
<1>
3
<1>
4
<1> Not available when H5-08 is set to 2 P1 (APOGEE FLN).
<2> Not available when H5-08 is set to 0 (MEMOBUS/Modbus) or 1 (Metasys N2).
n H5-03: Communication Parity Selection
Sets the parity used for communications.
Note: Cycle power for the setting to take effect.
No.
H5-03
Setting 0: No parity
Setting 1: Even parity
Setting 2: Odd parity
n H5-04: Stopping Method after Communication Error
Selects the stopping method after a communications error (CE) has occurred.
No.
H5-04
Setting 0: Ramp to Stop
Uses the deceleration time currently enabled.
Setting 1: Coast to Stop
Setting 2: Fast Stop
Setting 3: Alarm Only - Operation Continues
Setting 4: Run at d1-04
n H5-05: Communication Fault Detection Selection
Enables or disables the CE detection for communications.
No.
H5-05
Setting 0: Disabled
No communication error detection. The drive continues operation.
Setting 1: Enabled
If the drive does not receive data from the master for longer than the time set to H5-09, then a CE fault will be triggered and
the drive will operate as determined by parameter H5-04.
n H5-06: Drive Transmit Wait Time
Sets the time the drive waits after receiving data from a master until responding data.
Note: Cycle power for the setting to take effect.
No.
H5-06
YASKAWA ELECTRIC TOEP C710616 45F YASKAWA AC Drive – Z1000 User Manual
Communication Speed
1200 bps
2400 bps
4800 bps
9600 bps
19200 bps
Name
Communication Parity Selection
Name
Stopping Method after CE
Name
Communication Fault Detection Selection
Name
Drive Transmit Wait Time
4.13 Advanced Drive Setup Adjustments
H5-02 Communication Speed
<1>
5
<1>
6
<1>
7
<1> <2>
8
Setting Range
0 to 2
Setting Range
0 to 4
Setting Range
0 or 1
Setting Range
5 to 65 ms
38400 bps
57600 bps
76800 bps
115200 bps
Default
0
Default
3
Default
1
Default
5 ms
179
4