Changing tail lights (on the
rear lid)
Removing the bulb holder
Remove the cover from the boot lid.
Fig. 103
1)
For rear-lid LED rear lights, only the reverse and
retro fog bulb can be replaced. The illustrations in
the manual correspond to the bulb version and do
not correspond exactly to the LED version.
1)
Fig. 104
Remove the lamp holder
The rear lid must be open to change the
bulbs.
You can access the bulb holder for the inner
tail lights through the inside of the rear lid.
Check which of the bulbs is defective.
–
Fuses and bulbs
Open the cover to access the lights, turning
–
it by hand in the direction indicated by the
arrows.
Access the lights by disconnecting the con-
–
›››
nector
Fig. 104
and unscrewing
1
›››
Fig. 104
the bulb holder
. Take care not
to lose the bulb holder retaining screw.
›››
page
91.
Change the bulbs
–
Changing bulbs
Position of the bulbs in the bulb
Fig. 105
holder
The bulbs are secured with a bayonet fasten-
er. The table below gives an overview of the
›››
bulbs
table on page
92.
»
91