Control Terminals; Electrical Installation, Control Terminals - Danfoss FC 300 Design Manual

FC 300 Design Guide

6.3.6. Control Terminals

Control Terminals, FC 301
Drawing reference numbers:
1.
2.
3.
4.
Control Terminals, FC 302
Drawing reference numbers:
1.
2.
3.
4.

6.3.7. Electrical Installation, Control Terminals

To mount the cable to the terminal:
1.
2.
3.
4.
To remove the cable from the terminal:
1.
2.
1) Max. 0.015 x 0.1 in. [0.4 x 2.5 mm]
8-pole plug, digital I/O.
3-pole plug, RS-485 bus.
6-pole, analog I/O.
USB Connection.
10-pole plug, digital I/O.
3-pole plug, RS-485 bus.
6-pole, analog I/O.
USB Connection.
Strip isolation of 0.34-0.39 in [9-10 mm]
1)
Insert a screw driver in the square hole.
Insert the cable in the adjacent circular hole.
Remove the screwdriver. The cable is now mounted to the terminal.
1)
Insert a screw driver in the square hole.
Pull out the cable.
1.
MG.33.B9.22 - VLT ® is a registered Danfoss trademark.
6.11: Control terminals (all enclosures)
2.
6. How to Install
6
3.
121