Danfoss FC 300 Design Manual page 134

6. How to Install
1.
2.
See Brake instructions, MI.90.FX.YY and MI.50.SX.YY for more information about safe installation.
6
134
Connect the shield by means of cable
clamps to the conductive back plate
on the adjustable frequency drive
and to the metal cabinet of the brake
resistor.
Size the brake cable cross-section to
match the brake torque.
NOTE
Voltages up to 960 V DC, depending on the supply voltage, may occur on the ter-
minals.
MG.33.B9.22 - VLT
No. Function
81, 82 Brake resistor terminals
® is a registered Danfoss trademark.
FC 300 Design Guide