Danfoss FC 300 Design Manual page 139

FC 300 Design Guide
-
-
-
a.
b.
c.
d.
e.
f.
g.
The contact resistance between the individual shield conductors.
The shield coverage, i.e., the physical area of the cable covered by the shield - often
stated as a percentage value.
Shield type, i.e., braided or twisted pattern.
Aluminum-clad with copper wire.
Twisted copper wire or armored
steel wire cable.
Single-layer braided copper wire
with varying percentage shield cov-
erage.
This is the typical Danfoss reference
cable.
Double-layer braided copper wire.
Twin layer of braided copper wire
with a magnetic, shielded/armored
intermediate layer.
Cable that runs in copper tube or
steel tube.
Lead cable with 0.43 in [1.1 mm]
wall thickness.
MG.33.B9.22 - VLT ® is a registered Danfoss trademark.
6. How to Install
6
139