Danfoss FC 300 Design Manual page 26

3. Introduction to FC 300
Active Reference and Configuration Mode
The active reference can be either the local reference or the remote reference.
In par. 3-13
[2].
To permanently select the remote reference, select
3
Auto
Mode).
Hand On
Auto
LCP Keys
Hand
Hand -> Off
Auto
Auto -> Off
All keys
All keys
The table shows under which conditions either the local reference or the remote reference is
active. One of them is always active, but both cannot be active at the same time.
Par. 1-00
torque or process control) is used when the remote reference is active (see table above for the
conditions).
Par. 1-05
when the local reference is made active.
26
Reference Site,
the local reference can be permanently selected by selecting
[0] (default), the reference site will depend on which mode is active. (Hand Mode or Auto
Reference Site
Par. 3-13
Linked to Hand/Auto
Linked to Hand/Auto
Linked to Hand/Auto
Linked to Hand/Auto
Local
Remote
Configuration Mode
determines what kind of application control principle (i.e., speed,
Local Mode Configuration
MG.33.B9.22 - VLT
Remote
[1]. By selecting
determines the kind of application control principle that is used
® is a registered Danfoss trademark.
FC 300 Design Guide
Local
Linked to Hand/
Active Reference
Local
Local
Remote
Remote
Local
Remote