Printing Signal Array Data - GE Panametrics GF868 Programming Manual

March 2003
Printing Signal Array
Data
4-10
Use the SGNLS submenu to print signal array data, to help diagnose
certain problems. To print the signal data, refer to Figure A-5 on page
A-5 of Appendix A, Menu Maps, and complete the following steps:
IMPORTANT: Make sure that a printer has been properly set up
before proceeding with this section.
1. To access the Print Menu, press the
Note: The Print Menu is not protected by the security feature and a
password is never required to access this menu.
2. Press the [←] or [→] key to display the option bar shown, and
then press to select the
[F2]
3. Press the [F1]-[F3] keys to select the desired Signal Array data to
print. To abort the procedure, press the
Note: The
SIGNL option causes the raw signal array data to print,
while the
CROSS
print. The
BOTH
After the desired print selection has been made, the Model GF868
returns to the standard data display screen and normal measurement
taking. The specified signal array data is printed continuously, until it
is manually stopped. To terminate signal array printing, use the
submenu, as described earlier in this chapter. A portion of a typical
printout is shown in Figure 4-6 below.
CH1
0
1
2
.
.
.
757
758
759
760
761
762
763
.
.
.
Figure 4-6: A Typical Signal Array Printout
[PRNT] key.
submenu.
SGNLS
[EXIT]
option causes the cross-correlation data to
option prints both sets of data.
SKAN SIGNAL
0 0
0 0
0 0
40 44
41 45
40 42
34 34
32 34
36 38
36 36
key.
STOP
Printing Data