Entering Programming Mode - GE Panametrics GF868 Programming Manual

March 2003
Entering Programming
Mode
1-8
Use the keypad, as described in the previous section, to navigate
through the User Program. The menu map may be followed in
sequence, or the [↑] and [↓] keys may be used to scroll through the
prompt screens. The [←] key may be used to delete the last
alphanumeric character that was entered from the keypad.
The following discussion assumes that the left screen pane is active.
If the right screen pane is active, only the function key designations
change. That is, replace
Note: Be sure to record all the programming data entered in this
chapter in Appendix B, Data Records.
To access the User Program, press the
The standard measurement mode screen is replaced by the following
initial programming mode screen:
PROGRAM
PROGRAM
status
ACTIV SYSTM PIPE
Note: If the security feature is active, enter the password and press
the key to enter the User Program. See the
[ENT]
submenu section of this chapter for more information on the
security feature.
Programming of the
ACTIV
for operation of the Model GF868. Failure to accurately enter all of
the required information will result in unreliable flow rate data.
Therefore, be sure to complete at least the sections of this chapter
pertaining to those three submenus.
Note: Because it is so essential, instructions for programming the
, and
ACTIV SYSTM
Startup Guide. If that programming has already been
completed, those sections of this chapter may be skipped.
Except for the three submenus noted above, it is not necessary to
program the Model GF868 flowmeter in any particular order.
Therefore, the sections of this chapter need not be completed in
sequence. Proceed immediately to any section of interest.
with .
[F1]-[F4] [F5]-[F8]
key on the keypad.
[PROG]
Start
Press the [←] and [→] keys and
one of the function keys
to select the desired submenu.
From this screen, press
return to measurement mode.
I/O
, and submenus is necessary
SYSTM PIPE
submenus are also included in the
PIPE
Programming Site Data
[F1]-[F4]
[EXIT] to
SECUR