Log Type; Starttime Prompt - GE Panametrics GF868 Programming Manual

March 2003
Creating an ERROR
Log (cont.)

Log Type

STARTTIME Prompt

3-10
In addition, refer to Chapter 3, Diagnostics, of the Service Manual for
a discussion of the many parameters accessible via the
Note: The units assigned to the parameters in Table 3-2 on the
previous page are those selected in the User Program (
submenu).
6. Use the [←], [→] and
parameter to be logged.
7. Use the [←], [→] and
to be logged.
•
If you selected a totalized value for display, go to step 8.
•
If you did not, go to step 9.
8. At the Set Log Totals to 0 prompt, press
at their present value or press
Choosing at this prompt only resets the log totals to zero and
YES
has no effect on the meter totals.
9. Press [F1] to create a non-circular log or press
circular log.
A non-circular log automatically stops when the meter runs out of
memory or the specifed
continuously until manually stopped, but only the data from the most
recent log cycle is saved. At the start of each cycle, the oldest
recorded data is overwritten by the new data from the current cycle.
If data from one circular log cycle exceeds the meter's
memory capacity, the earliest logged data will be lost.
10.Press [F1] to accept the displayed start time or press
different start time. To start logging immediately, press
•
If was selected, proceed to step 11.
OK
•
If NOW was selected, you have finished setting up the error log.
Proceed to What's Next? on the next page.
•
If EDIT was selected, complete the steps listed on the next page.
[F1]-[F4] keys to select the second
[F1]-[F4] keys to select the third parameter
[F1] to leave the log totals
[F2] to reset the log totals to zero.
END TIME is reached. A circular log runs
Caution!
option.
DIAG
SYSTM
[F2] to create a
[F2] to enter a
.
[F3]
Logging Data