Recalling A Site - GE Panametrics GF868 Programming Manual

March 2003

Recalling a Site

1-36
Any site file currently stored in the Model GF868's non-volatile
memory may be recalled at any time. Up to ten site file names,
consisting of up to five characters each, may be stored at any given
time. While following the programming instructions, refer to Figure
A-3 on page A-3 of Appendix A, Menu Maps. Enter the
submenu by pressing [→] twice and
screen and complete the following steps:
1. Use the [←], [→] and
existing site file.
Note: The option bar shows only as many choices as there are
existing site files. The files are listed in chronological order by
creation date.
Upon recall, the selected site file becomes active and all of its
programmed parameters become current.
IMPORTANT: The
CLOCK
file, while the
with the site file.
Note: If you have loaded a site file into a GF868, but the option
cards are not in the same slots or programmed the same way
as when the site file was first saved, the GF868 displays a
warning to review slot information. This display does not
mean that the option cards have lost their program
information!
2. Use the [←] and [→] and
press to leave the User Program and return to measurement
[EXIT]
mode.
at the initial User Program
[F1]
keys to select and recall an
[F1]-[F4]
and I/O data is not recalled with the site
and
SYSTM COMM
[F1]-[F4] keys to select another menu, or
Programming Site Data
RECLL
data is recalled