End Date Prompt; Duration Prompt; Log Time Prompt - GE Panametrics GF868 Programming Manual

END TIME Prompt
(cont.)

END DATE Prompt

DURATION Prompt

LOG TIME Prompt

Logging Data
a. Press [F1]-[F2] to select
Hour (1-12) and press
the current time will generate an error message.)
b. Enter the desired Minutes and press
range is 0 to 59.
c. Enter the desired Seconds and press
range is 0 to 59.
13.Press to accept the displayed end date or press
[F1]
different end date. To end the log today, press
•
If or was selected, proceed to the
OK TODAY
prompt. Refer to Figure A-6 on page A-6 in
INCREMENT
Appendix A, Menu Maps for a flow diagram of the
programming sequences.
•
Otherwise, complete the steps below.
a. Enter the desired Year and press
0 to 99.
b. Use the [←], [→] and
Month.
c. Enter the desired Day and press
1 to the number of days in the selected month (28, 29, 30 or
31). The program proceeds to step 15.
If a circular log was specified, the programming sequence continues
here after the log start time and/or start date is entered.
14.Press and enter a log duration in hours or press
[F1]
a log duration in days. When the desired value has been entered,
press [ENT] . The program proceeds to step 16.
If TIMED was selected at step 12, the programming sequence
continues here.
15.Use the [←], [→] and
duration.The available options are: 10min, 30min, 60min, 3 HR, 6
HR, 12 HR and 24 HR.
AM or PM . Then, enter the desired
. (Entry of a start time earlier than
[ENT]
[ENT] . The acceptable
[ENT] . The acceptable
[F3]
. The acceptable range is
[ENT]
[F1]-[F4] keys to select the desired
[ENT] . The acceptable range is
[F1]-[F4] keys to select the desired log
March 2003
to enter a
[F2]
.
TIME
and enter
[F2]
3-5