GE Panametrics GF868 Programming Manual page 59

March 2003
Graphical Format (cont.)
2-10
Table 2-4: Graphical Log Display Options (Continued)
Option Bar Choice
→]
[ + [F1] = START
→]
=
[ + [F2] END
→]
[ + [F3] = YMAX
→]
=
[ + [F4] T INC
←]
[ + [F1] = EXIT
In the typical graphical display shown, the first logged parameter
(VEL) is shown to the left of the y-axis and there is a message line
below the graph that initially indicates the starting date and time of
the current page. Notice that most of the locator bar has been replaced
by a status line in standard video that shows the value, units and time
of the record at the current cursor location. However, there is still an
inverse video pointer at the far right of this line to indicate that
additional option bar choices are available.
Note: The date in the message line includes only the day and the
month (not the year), and the times in the status line and the
message line include only the hours and minutes (not the
seconds).
Because the times displayed in the
only, movement of the cursor may not result in a visible change in the
posted times. For example, if a
been programmed, two presses of either cursor movement key will be
required to change the displayed time by one minute.
Description
Move the cursor to the first record on the
current page and post the date and time of
that record in the message line:
(i.e. ST: 08 MAR 10:38
Move the cursor to the last record on the
current page and post the date and time of
that record in the message line:
(i.e.
END 08 MAR 11:14
Display the programmed maximum Y
value in the message line:
(i.e. YMAX 25.0 Ft/s )
Display the time increment value, as set
when the log file was created, in the mes-
sage line:
(i.e.
T INC 30 seconds
Leave the graphical LOG
return the display to the previous data for-
mat. (The [EXIT] key on the keypad will
also perform this function.)
graph are in whole minutes
LOG
TIME INCREMENT
)
)
)
display and
of 30 seconds has
Displaying Data